This was a good article and led me down the right path.  I had an issue with a 3702E AP that was in rommon mode.  This is the order of commands I used to resolve the issue.AP-in-ROMMON\ap:set IP_ADDR 192.168.xxx.yyyset NETMASK 255.255.255.0set DEFAUL...

I had this error as well. Found when connecting to a PA that I had to issue the "isakmp identity address" command to get Phase 1 to complete. https://supportforums.cisco.com/document/15196/how-use-isakmp-identity-address-command-configure-ipsec-vpn-t...

I was wondering if this issue has been resolved. Currently have several 3850 switches with this issue, ver 3.3.05SE. Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 56 WS-C3850-48P 03.03.05SE cat3k_caa-univ...