About initiaz.ali

initiaz.ali · 09-17-2019

Topology Above is the simple topology based on which I have the scenario which I would like to resolve: Notes:1. BGP running between routers2. Networks behind each ISP can transit into each other using DC1 and DC2.3. Site 1 - has TPG IPVPN connection...

initiaz.ali · 02-21-2020

Hi Marvin Your configuration doesn't work after reboot of the router ie when config is applied both tunnels pass traffic but after reboot or tunnel reset the DMVPN drops and stays in UNKNOWN state. Applying the crypto map to the source interface of t...

initiaz.ali · 02-21-2020

This is not possible according to Cisco Documetation/TAC Here is the restriction for IPsec when using crypto map and DMVPN:A crypto map on a physical interface is not supported, if the physical interface is the source interface of a tunnel protection...

initiaz.ali · 09-19-2019

Thanks Paul In fact I have come to the same conclusion that its not possible to control the preferred path for site with single connection when going from Site 1 to Site 2.The default path is being decided by the BGP using the lower AS-Path. I guess...

initiaz.ali · 09-19-2019

Hi Paul Correct. This is the simulation of our production network on GNS3. The only control in production that I have is on CEs.

Member Since	‎04-09-2018 07:01 PM
Date Last Visited	‎04-01-2020 04:53 AM
Posts	5

User Statistics

User Activity

BGP Routing

Re: I used CCP to build my

Re: Site to Site VPN and DMVPN on same router ?

Re: BGP Routing

Re: BGP Routing