I've recently replaced a number of Aironet 1250's (which ran in Autonomous mode) with 3800's now running Mobility expressIn this setup the access points aren't frequently used and are only powered on when needed (by PoE injector).The first thing I've...
Hello
I am using reverse telnet through the AUX port, with the input protocol as ssh
line aux 0
modem InOut
rotary 1
no exec
transport input ssh
transport output all
speed 115200
ip ssh port 2000 rotary 1
SSH'ing to port 2000 makes use...
I have one of these cards, configured like this:
interface Dialer1 ip address negotiated no ip unreachables ip nat outside ip virtual-reassembly in dialer pool 2 dialer idle-timeout 0 dialer string lte dialer persistent no cdp enable
interface Cellul...
Approximately following this example (am hoping this is sufficient without me pasting everything in here):
http://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/14122-24.html
I have been attempting to configure a IOS ...
I've just encountered some behavior with dynamic link aggregation between switches which I wasn't expecting -
I have this scenario, I'm expecting 2.0gbps aggregate bandwidth from the server to the PCs, and I get 2.0gbps, as expected
+---------+...
That option is disabled. But it doesn't look like it'd be any use anyway. (From the documentation):For a master AP, the Operating Mode field shows AP & Controller. For other associated APs, this field shows AP Only. The Make Me Controller button is a...
For security reasons I won't go into any more details of the scenario - I'd agree the APs alone may not burn much power, but if they were left on, they'd be doing nothing because switches are powered off at the same time too (along with a whole bunch...
I'm not going to disagree with your judgement of the application here. It is odd. I had a set of autonomous IOS APs installed in locations where they were only occasionally used, and were powered on by power injector when someone arrives (as previous...
Thanks for the insight.I just tried your suggestion. Setting an AP as its own preferred master does not remove the bootup delay.I am beginning to get the impression that these APs are not suitable for my application...The boot time of the 1250's was ...
> did you by any chance in the past have multiple AP's active at the same time?no > second do not use DHCP for assigning IP address to the "controller"I am not, however, it appears that it still requests an address via DHCP so it can look for a contr...
