Hi folks
First I create a SIP session from INSIDE to OUTSIDE. The inspection of sip was enabled so the media ports are opended accordendly which works fine - and the call takes place. I can also terminate the call by sending a BYE from INSIDE to OUTS...
Hi folks!
I want to deploy AnyConnect without a PKI - I want to use self signed certificates
First i create an RSA keypair for the Certificate
crypto key generate rsa label RSA_IDENT noconfirm
Enroll the Self Signed Certificate I use for the CN the O...
Hi All,I have devices which don’t send gratuitous arp when they plugged into a L3 switch. A problem occurs when one of this devices fails - and is replaced by another one (with another mac -- IP the same). The l3 switch doesn't...
HIQ1: On which size of my net or prefixes should i use OSPF area'sQ2: Is there any disadvantage to use OSPF Area's in smaller net's - in order of physical or logical grouping The Net i will built consists of 5 remote sides and each remote sides consi...
Hi Patrick
The cert from the ASA in the PEM - Format has only the public key in it. I "manually" give this public key on the client so there is no possibility that he get's a worng public key from the man in the middle.
max
Flex Link - Switch between an active and standby Port
TRILL ("Transparent Interconnection of Lots of Links") - Link State Routing on Layer 2
All flavors of STP (RSTP,MSTP..)
May be also BFD - Bidirectional Forward detection - It's commonly used for f...
check the mac-address table - if there are the correct MAC on the ifmay be you mirror the port's and check with wireshark what's going ontry the two port's in an different "dummy" Vlan and try to ping each other (maybe also change the IP's on the Hos...
