Good day Just for the record, it's working now, the problem was on the asterisk side GWVOIP_IMPULSE3#sh voi call sum PORT CODEC VAD VTSP STATE VPM STATE ============ ======== === ==================== ====================== 1:1.28 g729r8 y S_CONNECT CSM_IC7_CONNECTED Thanks a lot. Regards.
... View more
Hi Good day everyone I need your help please. i need to connect my cisco as5300 to a third party cel provider with asterisk. something like this my agent dial a cel phone number-->cisco as5300-->internet-->asterisk-->final user (more less) here is my configuration of the dial-peers: ! dial-peer voice 200 voip description LINK TEST AST huntstop destination-pattern . voice-class codec 1 session protocol sipv2 session target ipv4:220.127.116.11:5060 ! dial-peer voice 201 pots description LINK TEST AST preference 1 max-conn 30 destination-pattern . direct-inward-dial port 1:1 ! i have an ACL access-list 1 permit 18.104.22.168 And this is what it shows me with show call history voice brief Total call-legs: 2 1968 : 9343518hs.92 +-1 +31 pid:200 Originate 0444423338885 dur 00:00:00 tx:0/0 rx:0/0 39 (bearer capability not authorized) IP 22.214.171.124:0 rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8 1968 : 9343518hs.93 +-1 +105 pid:201 Answer . <-----(it supose that here must be the dialed number) dur 00:00:00 tx:0/0 rx:0/0 39 (bearer capability not authorized) Telephony 1:1:92: tx:0/0/0ms None noise:0dBm acom:0dBm On the asterisk side, what the cisco sends is only a "." I can't find where i am wrong. Please help me Thanks in advance Kind regards.
... View more