Hi Experts,I am facing problem to configure MWAM. I have installed MWAM module in 6506-E slot 2 with sup720-3B. After installing MWAM the Status is PwrDown. I tried to turn on the power but its not happening. MWAM is installed in slot 2 and here is t...
Dear Experts,I am configuring ITP. I am not able to configure more than 8 time slots. As soon as I add any other time slot CPU utilization goes up to 100%.Kindly have look into my configuration. show runBuilding configuration...Current configuration ...
Hi,I am going to use Supervisor 720 on 6506. Two things I wan to make sure can Sup720 handle the BGP table.and I am goint to use WS-X6516A-GBIC for one Gig fiber link. Kindly suggest me any alternative module if this one is not suitable and also expl...
Hi,I am working on Cisco 6505 with Supervisor 720. I was playing arround with configreg and some how deleted or corrupted my IOS Image. Now When switch on my Switch its goint to Rommon mode. I downloaded image in flash disk(disk0). When I tried to bo...
Hi All,I am working on Catalys 6506 with Supervisor WS-X6k-S2U-MSFC2. I am trying to get the MAC address table. Show Mac address-table command is not working. Kindly help me in that situation
Dear Phillips,Thank you so much for your help. It is 100% fine . My MWAM is up. I am using 12.2(18)SXF. Thanks again.Now I am facing another problem. I wonder if you can help me. My GGSN is not responding to PDP-Context request. Here is my configurat...
Hi,What happening is when I boot my switch and enter "show bootvar" I found no value setted. Than I set the bootldr value and pointed boot image with those commandsconfig-register 0x2102boot system flash sup-bootflash:xxxxx.binboot bootldr bootflash:...
