When we had the old Firepower console for ASA module, the reporting would show DNS host resolution for internal and external hosts. This was useful to see at a glance what hosts were being shown in the reports without having to cross reference intern...
Is it possible to show resolved hostnames in the FMC reports? It was an option I enabled on the old Firepower system for ASA but I can't find it anywhere on the new FMC for FTD. I've looked everywhere. It's not a big problem at all but I do weekly re...
We've just put in ISE to replace our old ACS applicances. One of the main operations is wireless authentication on client MAC addresses. Over time, the host database has grown and I'm certain there are a large number of unused devices still registere...
Good afternoon, We have a fibre 1Gbps link between two office buildings. This runs down a single 4-core fibre. The remote office building has grown over the past few years and there is a concern that the single-fibre could get damaged and render the ...
Is there a way to "enforce" the "Away" timeout in Jabber or at least change it back to 20 minute default every time it launches? Our CEO would like us to set this the same for all users. We managed to do this for Lotus Sametime in a round about way b...
That's it! I would never have looked there in a millions years, thank you very much Marvin, much appreciated. I've enabled the Resolve IP Addresses (where possible) and now I see the host names in Event view, which I assume will also show in the sche...
Hi there. As far as I can tell, DNS is configured for the cluster - in Object Management, DNS Server Group, we have our internal DNS servers. We are also using internal hostnames for our SMTP and Remote Storage so that part must be working. It seems ...
The link is in and operational - dropping the fibre connections fails the connection over as required and fails back when the link is restored. Spanning-tree on the local switch is blocking all VLANs as expected for the wireless bridge interface. On ...
Thank you Reza - from what I have seen, 1Gbps interfaces get a default STP port and VLAN cost of 4 and 100 Mbps is 19 so I imagined this would work exactly as required without changing any defaults. I just wasn't sure if it was be quite that easy! On...
Thank you both for the responses. I see we already have the status timeout set to 20 minutes in the Jabber XML file. I've changed mine to 15 minutes as a test and relaunched the software, it seems to retain the custom setting (which I guess is expect...
