Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone; I have moved on to the next phase of this deployment. We have two CME routers. Calls are working by not transferring to the mailbox. Site A:Cisco ISR 1861WAN: 172.16.2.4, Unity 172.16.2.5Phones: 172.16.5.0/27 Site B:Cisco UC520WAN: 1...
Hello Everyone,Looking for a little assistance on a lingering issue, we have a mailbox that is linked to an extension number as well as a DID. When a call comes in on the DID (E164 number in the config) the envelope plays the extension number as the ...
I am not sure if I am just looking at this the wrong way and not searching for the correct information to get the answer I need. I have been messing with this for about a year now and can not seem to find the answer. I have 4 DIDs with my SIP provide...
Hello Everyone,
I think I am so close to getting this working. The first dial-peer accepts the call from my provider. The invite comes to 1777XXXXXXX. I have attached a sip-profile to this dial peer:
voice class sip-profiles 2request INVITE peer-he...
Hello everyone,
The support forums, Reddit, and a little outside help has gotten me a long way in this project and I have learned a lot too. However, that being said the solutions we came up with was never really what I wanted (using VoIP gateways ...
Thanks for the tips I might have to pull some debug logs to see what is happening as the call is being routed to Unity and what is in the headers. Just doesn't seem like that calling party's caller ID information is being transferred to Unity. In tur...
@Vaijanath Sonvane Thanks for the help I was able to get the remote site voice mail working....still having issues with the caller id information in the saved message. Steps in the right direction though.
Thank you @Vaijanath Sonvane I will give these suggestions a try, I know I did not have dial peers for the CUE on each side and I was thinking that might be the issue. I will update after testing and pull some debug logs. Thanks
I think where I am getting lost is can this be done in one dial-peer? I know with the inbound DIDs I need to use 2 dial-peers to make this work, first copying the called number than do the DID routing. My ITSP does the same thing with incoming calls,...
I was thinking about this some more and I think I have the 4 steps that I need to do: Strip the 9 from the dialed numberCopy the FROM: numberCopy from to the P-ASSERTED-IDENTITY headerChang FROM to 1777XXXXXXXI think everything would work
