Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any reason why the (.) wildcard would network on a CME?I get a fast busy after the 4. If I change the dial-peer to 2541... I get the fast busy after the 1dial-peer voice 1 voipdescription OUTbound to CUCMdestination-pattern 254....session pr...
I have 10 phones, some SCCP, and some SIP, different modal numbers, all registered and good to go. I changed the Starting and Ending Directory Number on the CUCM 10.5 and now no phones will register. I deleted the security settings and no joy. If I c...
I have DMVPN working on 7 routers all are 4331 with 16.9.5. I am using NHRP but not crytop All is working well, But when I try to "Show DMVPN" I get invalid input after the d I ideas?Again DMVPN is work with a dynamic tunnel spoke to spoke when nee...
Hi everyone.I have a small lab with 1 router, switch, and two phones:Router IOS version: Cisco IOS XE Software, Version 16.06.05CME version: Router#sh telephony-serviceCONFIG (Version=12.0)The phones are 7945s, and both are registered and can call e...
have a 4331 router with CME 12.0 at a remote site, and a CUCM Ver 10.6 at the HQ. the 2 sites are connected vi a WAN. I would like SCCP phones on the CME to be able to send and receive calls to SCCP phone on the CUCM. There is no PSTN, just IP.
(1)...
Thank you for your reply. This CM is in a training environment, and I need to change the DNs for whatever unit comes through. After every training event, I delete all the phones out of the CM, I believe this also deletes the DNs.
all working, registered phones unregistered, as soon as I change the auto-registration DN range starting Directory Number and Ending Directory Number. Then once I changed the numbers back everything re-registered? I tried everything on the phone up t...
the only change was to the starting Directory Number and Ending Directory Number it was 2546000 to 2547000, I changed them to 254 1000 to 2542000. all registered phones unregistered, and no new phones would register. Once I changed the starting Dir...
