Hello, I have an NCS540 terminating 10GE to a Metro-E provider.  I need to set 2 Gbps CIR shaping and need to have a small 2ms committed burst (Bc) facing that provider.  But unlike ASR9K, I can't configure burst when doing shaping on NCS 540 and ser...

When doing multi-hop async BFD sessions on ASR9K, the following restrictions / caveats are noted:1.  HW-offload is not supported2.  LC CPU which hosts the session is randomized according to line cards listed under 'multipath include location X/X/CPU0...

Hello, Lately, I've seen two outages (both on ASR 9901/Starlord) with external TCAM error either causing LC0/0/CPU0 to reboot, or both NP0 and NP1 to completely lock up, destroying all forwarding traffic until 0/0/CPU0 is manually rebooted or remote ...