About sergo777

sergo777 · 12-07-2022

Hello, I have router 1111 and Switch 1000, between them is trunk with 5 VLANs, default gateways sitting on the router. Just two VLANs have Internet access (VLAN 10 - via VPN to core router, and VLAN 99 local NAT) - Switch has default gateway comman...

sergo777 · 10-17-2022

Hi Everybody, sorry maybe stupid question. I need to reach another server via VPN (in this case FTP server, i need to download a new IOS) from router with some interfaces. I can ping and reach this server when i use source from specific interface (lo...

sergo777 · 03-02-2022

Hi There,I need to run only specific traffic inside VPN (for example HTTPS and ICMP). How to do it? i couldn't find solution. This one, looks like different:IPsec Data Plane Configuration Guide, Cisco IOS Release 15M&T - Crypto Access Check on Clear-...

sergo777 · 09-02-2020

Hi EverybodyMaybe somebody saw same issues.I have Cisco controller 3500 and some access point 2702, some of them sitting in branch offices, connected via VPN. Some offices have also Cisco and some Fortinet-s, Cisco use DMVPN and Forti standard VPN wi...

sergo777 · 07-15-2020

Hi There,I saw some discussions about same issue, but didn't find a final solution. I have DMVPN connection between head office and branches. Everything works fine, branches receiving routes via DMVPN and OSPF, but when i try to route all traffic to ...

sergo777 · 05-05-2023

no, upgrade didnt help, but all forti gone, replaced to cisco-s and problem gone

sergo777 · 12-09-2022

Thanks Paul, yes, its classic config, i have it everywhere ... not sure why it doesnt work for this switch.

sergo777 · 12-08-2022

Thanks Paul, i tried to switch it to normal L3 (removed ip def-gw) and create 0.0.0.0 -> gw it also doesnt work... my understanding - 10.10.99.1 should be default GW for .99 network and after that it should reach 10.10.10.0 network... Paul, do you ...

sergo777 · 12-07-2022

right. but in this case i will block my management IP 10.10.99.2 yes i can create Loopback but i have add it to VPN domains etc

sergo777 · 12-07-2022

Thanks. Yeah i know, i created interface on switch side just for test purposes. I dont need any IPs on switch side, its L2 (just one for management)ACLs - i need to block access to internal networks, because VLAN99 will be like Guest network with int...

Member Since	‎04-18-2018 10:16 AM
Date Last Visited	‎06-21-2023 03:27 AM
Posts	31
Total Helpful Votes Received	31

User Statistics

User Activity

Routing in switch (ip default-gateway command)

Source IP

ACL inside VPN

Access Points CAP2702 don't see controller

Default routing via VPN

Re: Access Points CAP2702 don't see controller

Re: Routing in switch (ip default-gateway command)

Re: Routing in switch (ip default-gateway command)

Re: Routing in switch (ip default-gateway command)

Re: Routing in switch (ip default-gateway command)