About roliveira11

roliveira11 · 03-18-2020

Hello Cisco Community!!I have an ASA5512 running 9.1(2) firmware with 4.x anyconnect software package and with 250 remote access vpn licenses installed but only 6 users can connect at a time. There seems to be no vpn session limit set in group-policy...

roliveira11 · 11-19-2019

Hello Cisco Community! I have a 3750 acting as WAN switch connected to CrownCastle and MetTel I was able to get the routing up for the CrownCastle side as that circuit was available/installed first..so the default route that's configured routes to Cr...

roliveira11 · 11-05-2019

Hi Cisco Community! I have a silly question. I'm looking to configure an ACL to allow 10.0.1.43 to ONLY be able to communicate with 10.0.254.52 via any protocol but no other machines or internet. The machines are part of the same broadcoast domain b...

roliveira11 · 10-28-2019

Hello Cisco Community! The subject line really says it all. I'm working on extending an existing Verizon FIOS wifi connection/SSID within an apartment. I have two spare Cisco Aironet 2602i wireless access points I could use. I wanted to ask if there ...

roliveira11 · 10-03-2019

Hello Everyone,It may very well be the time of day I'm writing this and long hours of looking at the screen.. but I'm setting up a lab ASA with an inside and outside interface. Inside interface is connected to a L3 Nexus 3064 using a transit VLAN ( 1...

roliveira11 · 03-20-2020

I'll have to figure out how to retrieve the DART logs

roliveira11 · 03-19-2020

Hello! Thank you for the reply! The setting was set to INHERIT on the group policy.. we've since hardset it to 250.. and still only 6 users can connect.. when attempting to do debugs on anyconnect.. I see none.. attempting to do captures on outside i...

roliveira11 · 11-19-2019

Hi Georg! IPServices is enabled! Thanks for asking! Based on everyone's feedback, It sounds like the next best course of active is to configure the "sdm prefer routing" command, wr mem, and reload the switch. HaemoWANswitch#show licenseIndex 1 Featu...

roliveira11 · 11-19-2019

Got the show SDM Prefer output--- desktop default template?!?! HaemoWANswitch#show sdm preferThe current template is "desktop default" template.The selected template optimizes the resources inthe switch to support this level of features for8 routed i...

roliveira11 · 11-19-2019

Hi Paul, THanks for the reply! Maybe you did not catch my previous posts of my CLI output- but I was showing that I was going into the L3 interface, applying the ip policy route-map command, the switch taking it, but when looking at the running-confi...

Member Since	‎11-28-2015 07:00 AM
Date Last Visited	‎03-20-2020 12:07 AM
Posts	31

User Statistics

User Activity

Cisco AnyConnect - cannot have more than 6 users connected

Routing to two ISP's with one L3 switch - using route-maps

Configuring Extended ACL - for 2 machines

Configuring Aironet 2600 as a Verizon FIOS repeater

Internal Subnets not getting OUT to internet ASA 5512

Re: Cisco AnyConnect - cannot have more than 6 users connected

Re: Cisco AnyConnect - cannot have more than 6 users connected

Re: Routing to two ISP's with one L3 switch - using route-maps

Re: Routing to two ISP's with one L3 switch - using route-maps

Re: Routing to two ISP's with one L3 switch - using route-maps