About elnekramer

elnekramer · 11-12-2019

Hi! I have created 2 mpls TE tunnels, which load balances over 2 different links, using explicit-paths, to the same destination. I would like to know, if the one physical link, experiences packet-loss, how do i get the mpls TE tunnel to just go down,...

elnekramer · 11-12-2019

Hi!I have created 2 mpls TE tunnels, which load balances over 2 different links, using explicit-paths, to the same destination. I would like to know, if the one physical link, experiences packet-loss, how do i get the mpls TE tunnel to just go down, ...

elnekramer · 11-12-2019

elnekramer · 11-30-2015

Hi There! i would llike to know what this error message on my logs mean, also in particular with the "suppressed 719 times" . Could this affect memory usage? if so, how do i clear memory usage on a switch *Nov 30 09:12:00: %C4K_L2MAN-6-INVALIDS...

elnekramer · 11-18-2019

Hi!the problem is, i dont have the "applet" command option:this is an:Cisco IOS XR Software, Version 5.3.4[Default]Copyright (c) 2017 by Cisco Systems, Inc.ROM: System Bootstrap, Version 3.04(20160331:102636) [ASR9K ROMMON],cisco ASR9K Series (P4040)...

elnekramer · 12-01-2015

the only one is see every now and again is: addto_mempool_pc_array(): overflow this is also the memory allocations: BRY-CS1#sh mem all tot Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)Processor 137ED198 209792...

elnekramer · 12-01-2015

BGP is a path vector routing protocol. It actually uses hop count " Autonomous systems" for path selection provided the next hop must be reachable. BGP uses these attributes in this order for path selection, until it finds an attribute that is not a ...

elnekramer · 12-01-2015

True, found the mac address, and it seems that it was not a mac address with a valid vendor, problem is,, my switch's memory is still high, and not sure how to dump/clear the memory without rebooting

elnekramer · 12-01-2015

Hi The command R1(config)#enable password mypassword is the correct global configuration command for configuring a password for enable or configuration mode. You can also use R1(config)#enable secret mypassword as this will encrypt the password. ...

Member Since	‎11-30-2015 10:33 PM
Date Last Visited	‎11-19-2019 01:16 AM
Posts	9

User Statistics

User Activity

MPLS Traffic-engineer Tunnels still stays up with packetloss

MPLS Traffic-engineer Tunnels still stays up with packetloss

test

Switch memory and invalid source mac address

Re: MPLS Traffic-engineer Tunnels still stays up with packetloss

the only one is see every now

BGP is a path vector routing

True, found the mac address,

Hi