About nileshgore25

nileshgore25 · 07-25-2021

i,How many ports and vlan combination (source paths) across all the span source groups can be added on a ToR switch ?1) when no filters are configured2) when filters are configuredExample :If there are 3 source groups configured on a ToREach source g...

nileshgore25 · 04-22-2021

Hi experts,We will be doing ACI upgrade from 3.2(5e) to 4.2(7f)our ACI fabric have around 12k endpoints learned in EPGs associated with L2 BDs (unicast routing disabled, ARP flooding enabled, gateway not on ACI) as well as other EPGs associated with ...

nileshgore25 · 10-12-2020

Hi,I am in the process of building an ACI simulator in our lab environment.The ACI simulator VM is deployed on an ESXi host which is connected to an actual physical ACI fabricDuring the initial setup, I configured IPv6 OOB mgmt IP address on the ACI ...

nileshgore25 · 08-31-2020

Hi ACI Gurus, I want to understand how to check the TCAM utilization on ACI Leaf switch.I found below information but not able to correlate altogether. The following link shows that for Nexus 9300 switch the default TCAM allocation, SPAN is assigned ...

nileshgore25 · 05-19-2020

Hi,As per "Cisco APIC Layer 3 Networking Configuration Guide"For IPv6 ND, ACI bridge domain ND always operates in flood mode; unicast mode is not supported.Does it mean that for IPv6 ND traffic the BD will operate in flood mode regardless of the sett...

nileshgore25 · 07-25-2021

@egoepfert , Thank you for your response. Policy CAM is not same as TCAM per the blog on the URL mentioned below.https://unofficialaciguide.com/2021/01/06/understanding-aci-tcam-utilization-optimization/ My Aim to identify the TCAM space is to check ...

nileshgore25 · 04-23-2021

Thanks for confirming about the endpoint DB not maintained across reboot.We have planned upgraded of switches in multiple odd even groups spread across one week per fabric. I did considered state checker app, but I found it very slow (unresponsive af...

nileshgore25 · 04-22-2021

I think this is expected, when the peer is down.In my case I was able to see the BGP neighbor via CLI in idle state for sometime immediately after I pushed the configuration. And the entries got cleared after few minutes.the neighbor entry should sho...

nileshgore25 · 02-27-2021

The following query will give EPG static bindings for all paths VPC as well as for non-VPChttps://{{apic}}/api/class/fvRsPathAtt.json?rsp-subtree=full&rsp-prop-include=config-only if you have used some naming convention for VPC policy groups, like if...

nileshgore25 · 02-17-2021

try the following moquery from the apic moquery -c fvAEPg -x query-target=children target-subtree-class=fvRsBd | egrep "dn|tRn"

Member Since	‎12-02-2015 04:53 AM
Date Last Visited	‎07-29-2021 07:54 PM
Posts	26
Total Helpful Votes Received	15

User Statistics

User Activity

ACI SPAN - Number of source paths on a ToR

Endpoint database after fabric upgrade

ACI simulator IPv6 OOB mgmt issue

ACI SPAN - TCAM utilization identification

ACI Bridge Domain IPv6 ND

Re: ACI SPAN - TCAM utilization identification

Re: Endpoint database after fabric upgrade

Re: [DUAL STACK]BGP v4 Peering on Cisco ACI

Re: Static Port Bindings Report

Re: Reporting on all EPG Bridge Domains Question