About jmills001111

jmills001111 · 12-03-2015

I have a couple of SFP in my network for which I have no Data Sheets. They are installed in a Cisco IE 3010 Switch. The information that I can obtain is as follows: Cisco-Avago Part No SFCT-5798PZ-CS2 ser no AGC1420UAM5 and AGC1420UAN3. I have contac...

jmills001111 · 04-26-2016

The command to show the Optical Rx and Tx levels is: show interface <int id> transceiver detail it works on WS 3560 Switch but not on 4560 switch. The command transceiver type all does not work on 4560 either, despite being shown in the manual. Rega...

jmills001111 · 12-08-2015

Thanks Tom, I was thinking that one 1550nm Tranceiver Receiver was totally blind to the other 1310nm Tranceiver Transmitter, so this answers why I have a working link. The long term plan will be to correct the mismatch.

jmills001111 · 12-04-2015

Hi Marvin, That's what I thought, but then the system is working, and what is more I have found mismatched pairs elsewhere along the system (it is a chain of IE3010 switches). The engineers will be attending site and swapping them out.

jmills001111 · 12-04-2015

Thanks, it certainly helped. Unfortunately the description of the SFP from the switch is 1000baseLX, ie 1310nm, but the SFP at the other end of the link is 1550nm, The AVAGO sfp fitted do not have DDM so I am unable to get any Tx or Rx signal levels....

Member Since	‎12-03-2015 02:56 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

Datasheet for SFP

The command to show the

Thanks Tom, I was thinking

Hi Marvin, That's what I

Thanks, it certainly helped.