I wounder whether this would be possible: consider the following:serverone GE#1 configured as 192.168.42.11 255.255.255.248 gw 192.168.42.9 on DNS server as serveroneslow.somewhere.com
servertwo GE#1 configured as 192.168.42.12 255.255.255.248 gw 192...
I have a 1921 which had a HWIC-4ESP (the older FastEthernet) installed and then I installed a newer eHWIC-4ESG-P alongside. When I did not see any Gigabit interfaces for the newer eHWIC-4ESG-P I came across this document stating that it won't work al...
new features in version 9.1(5) released March 31, 2014 Improved one-time password authentication Administrators who have sufficient authorization privileges may enter privileged EXEC mode by entering their authentication credentials once. The ...
I would like to reach n.n.n.n over the internet with the default route in placeor with a static route when the default route is not set:ip dhcp-client default-router distance 253interface FastEthernet 0/0 ... internet gatewayip address dhcp... makes ...
ip dns server ... I have the DNS server configured as follows:ip dns server view-group dnsVLcustomip dns view-list dnsVLcustom view dnsVcustom 1ip dns view dnsVcustom no domain lookup dns forwarding dns forwarder 208.67.222.222 dns forwarder 208.67.2...
regarding your proposed option 1: I know, it should be the easy and proper way but as I mentioned I want 10GE and I do not have a 10GE switch so this is out-of-the-question.regarding your proposed option 2: this is what I was asking advice for, the c...
The two server should bypass the switch on their alternate dedicated interfaces not on their primary "default" interfaces which will remain configured as dot1Q on the switch for normal traffic. I never stated/mentioned/requested dot1Q on their dedica...
Ahhh guessing this is the small letter buried-sooo-deep-in-the-manual that Cisco is famous for. Tons of useless and obvious wording in the manuals and what really matters you have to look very deep to find. Well, anyway I suppose this explains the ca...
I can confirm that I have this problem too on C1921 running 15.8(3).M5 with a brand-new 4ESG-P: My specific card is eHWIC-4ESG-P and note that my C1941 it is ALSO Hw Revision: 1.0 ... it is starting to feel there's something more to it than a bad car...
thanks for your reply Georg Yes, I was aware that the command reference states 9.2(1) as the release in which the auto-enable option was added but it is not correct since I am running 9.1(7) and I already have this option present. There's an entry on...