Hello Does anyone know how to send custom cli command through REST API to the CSR 1000v router. The documentation specifies the resource (/api/v1/global/cli), but without details. Best regards, Uros
HelloI have two WSA appliances and I want to make automatic configuration synchronization with script.So here is my question. When I load configuration to secondary appliance, do I have to load whole configuration or I can only load the xml file with...
I was able to configure the CWA on the switch and Cisco ISE. It is working as expected. I followed the guide on the link bellow.http://www.cisco.com/en/US/products/ps11640/products_configuration_example09186a0080ba6514.shtmlI only have one question. ...
HelloDid anyone experience problem with Service Selection Rules in Cisco ACS. When I click this tab ( it only works for me in google Chrome), configuration is normally opened. But when I want to edit one of two default rules (rules that match radius ...
HelloI need some help with Topology services in Campus Manager application in LMS. I have some branches in our network. They are connected to our LAN network through IPSEC/GRE tunnels over WAN network. I would like to show these links in topology ser...
I took configuration from wsa1, deleted part of the configuration that I knew it didn't change, changed IP addresses and upload only partial config file. It was loaded without issues and configuration changes were applied to the wsa2. So it looks li...
Thank you for the answer. It must be this because I tested this solution with and without access-list on the port and the result was always the same.BR
HelloThank you. It worked. I enable CDP on Tunnel interfaces and devices are now connected in Network topology view.I have additional question. I also have ASA FW in our network. Is it possible to display ASA connection in network topology view?Uros