Hello,Can someone help me on the case below?We have a Cisco CATALYST 6506, CatOS based, with the following config:Switch 6506 (enable) sh verWS-C6506-E Software, Version NmpSW: 8.4(5)System Bootstrap Version: 12.2System Boot Image File is 'bootdisk:c...

Hello,Can anyone help me with the case below:I'm trying to replace a SUP module on Cisco CATALYST 6509. (Cat OS)After I insert the new module I got the error:SYS-5-SUP_REDMISMATCH:Standby supervisor 2 redundancy/power mgmt board detection mismatchand...

Hello, Good morning     Can anyone help me with the case below?     We have a Cisco aironet 1162N connected to a Wireless Controller (LIGHTWEIGHT mode), the device failed and it needs to be replaced.     We have a Cisco aironet 1142N in stock availab...

Hi everyone,I have an alert from monitoring system about: “ fan for this system is not in the NORMAL state”.In the switch I found that the problem is with fex 3, see below:Nexus5020# sh env fex 3 fanFan Fex: 3:----------------------------------------...