Hello,I tried the commands above, without results:Switch 6506 (enable) disconnect 18.18.18.18Usage: ...

I'll try with router#clear line vty 1-10Also, I tried:Switch 6506 (enable) disconnect 2Telnet sessio...

Yes, I tried buy CLI didn't accept this command.

Hello,Can someone help me on the case below?We have a Cisco CATALYST 6506, CatOS based, with the fol...

Hello,Can anyone help me with the case below:I'm trying to replace a SUP module on Cisco CATALYST 65...

ok, I´ll connect it to the WLC and let you know if a have any other issue.Thanks!

Hello, AP: 1262 is dead. I'm not able to see old configuration. new AP is not connected to the netwo...

Hello, I need to connect the replace device: AP model 1142N, I'm not able to see the configuration n...

Hello,yes it is 1262, no sure the process that AP learn the controller IP, but we have several AP's ...

Hello, Good morning Can anyone help me with the case below? We have a Cisco aironet 1162N connected ...

Hi, Thanks for your help.Fex module was manually reset and the problem was resolved.

Hi everyone,I have an alert from monitoring system about: “ fan for this system is not in the NORMAL...

Thanks a lot, yes the problem was the power supply, it needs to be replaced.Tech reset it and it did...