Hi,I have an SG300-10P but it doesn't seem to working as expected, so I need some help getting the configuraiton correct. I have a workstation on a vlan (998) but it can't ping a host on the internet (8.8.8.8) but from the switch I can ping 8.8.8.8. ...

So the SG300's have STP on them and prevent network loops when other switches on the network also support STP too.  However, if someone plugs in a non-managed switch that doesn't support STP with a network loop, is there anything within the SG300 swi...

We are looking to an issue where we may have an SG-300 28P switch that might be causing problems on the network.  The switch is placed in an IDF that is close to the roof and someone raised the possibility that it might be overheating in the afternoo...

Hi,I'm going to have several SG300-28P switches to setup.  I'll need to create multiple vlans for data, voice, and wireless traffic.  I have the following questions in setting up this configuration:VLAN 1 ManagementVLAN 100 DataVLAN 200 WirelessVLAN ...

I've got a Cisco SPA303 phone that is stuck at "Initializing Network".  How do I factory reset it?  I can't seem to get into any configuration menus or settings.  The manual says to press **** and choose 4 and hit # but nothing happens.  Is there som...