About cadamwil

cadamwil · 09-25-2023

I have a Cisco IR1101 router with a Network Essentials license. Previously I have setup the router with a VPN and shipped camera traffic back to our main location. However, I have since found out that across the VPN camera traffic is not supported ...

cadamwil · 09-07-2023

I wasn't sure if I should place this in the switching or routing sub-forum of Networking. I have a IR1101 I have begun to setup. This is the second I've setup and I mostly copied and pasted the config from the first IR1101, which is working as inte...

cadamwil · 06-21-2023

I have been having an issue getting a IKEv2 Point-to-Point VPN between my Sonicwall and an IR1101.I was able to get IKEv1 working, but wasn't passing traffic, likely a NAT rule needed or a route. However, I decided I would rather just get IKEv2 worki...

cadamwil · 04-10-2023

Hello, I have a Cisco ISR4331 that is being used to route traffic from my ISP to my firewalls. I am looking to use Gig0/0/1 and Gig0/0/2 for my firewall's WAN connections, and they are redundant firewalls. Would the best configuration for this be s...

cadamwil · 09-11-2023

Issue turned out to be removing the ip access-group Allow_CH_CCTV-to_LAN in from the VLAN1 interface. Worked with TAC to get it solved.

cadamwil · 06-22-2023

FYI, I can ping the IR 1101's lan from the Sonicwall side, but not the devices on the lan. So 10.10.55.21 can ping 10.75.55.1, but not 10.75.55.51. However, those devices are up and responding on the Cisco side.

cadamwil · 06-22-2023

That helped with the transform. After that, I was able to get the VPN using IKEv2 across a VTI tunnel. The steps I used are below. However now I seem to be missing something on the firewall side. I have pings running from my server on the sonicwa...

cadamwil · 06-21-2023

OK, so I nuked the previous VPN configuration to attempt to create an IKEv2 VTI VPN between the sonicwall and my IR1101.Loosely basing it on this document from sonicwall, where they do it with IKEv1. I swapped the sonicwall side for IKEv2. Here is ...

cadamwil · 06-21-2023

That's the guide that I used to get IKEv1 working, but It seems to be missing things for IKEv2, especially on the Cisco IOS side. The Sonicwall, it's a drop down selection to go from IKEv1 to IKEv2, in fact the screenshots show IKEv2, but looking at...

Member Since	‎04-23-2018 08:37 AM
Date Last Visited	‎10-19-2023 06:44 AM
Posts	11
Total Helpful Votes Received	2

User Statistics

User Activity

NAT & ACL advise or ??

IR1101 - VLAN issue? Unable to ping

Issue getting a IKEv2 P2P VPN between Sonicwall and IR1101 IOS XE 17.8

Bridging interfaces on ISR4331

Re: IR1101 - VLAN issue? Unable to ping

Re: Issue getting a IKEv2 P2P VPN between Sonicwall and IR1101 IOS XE

Re: Issue getting a IKEv2 P2P VPN between Sonicwall and IR1101 IOS XE

Re: Issue getting a IKEv2 P2P VPN between Sonicwall and IR1101 IOS XE

Re: Issue getting a IKEv2 P2P VPN between Sonicwall and IR1101 IOS XE