HiThe Cisco LMS 4.2 installation went without hickup, and it works fine.When i try to upgrade to 4.2.2 i get a error during the installation that some files are locked.I checked the documentation, it says nothing about stopping services before the up...
I have just started evaluation of LMS 4.2.During the installation i was asked to set a password.I am trying to log in with that password, with username admin, administrator, without luck.Is admin username something else ?
Hi, i started getting this weird error message yesterday in WCS.http://dl.dropbox.com/u/10913656/xda/Clipboard02.jpgI have some generic and some per location templates.Admin status on/off, hreap enable are generic.Then i have templates for every loca...
Yes.You have to do it per interface in each context.In the system context you allocate interfaces only.Then in each context you have to add standby ip to each interface. I havent found the option to add standby in ASDM, i always use CLI.It is probabl...
HiAs far as i know, you have to add a standby address for all physical and logical interfaces.Active asa in the cluster always assumes the interface address, and the passive one assumes the standby one.I am no ASA expert, but these are basics :)
You need to add failover configuration in system on the present asa.Then switch the new one to multi mode, and run the same failover conf in the system context.Simple config :failoverfailover lan unit primaryfailover lan interface Failover GigabitEth...
I ran the net stop command, and checked the task manager, it is stopped. Now i got a even longer list.I tried setting the manager to manual in services.msc and then rebooting, it still throws me the same error.http://bildr.no/view/1276957
Hi Stephen. The template has the reboot option clicked in. The aps i used to stage before used to reboot after i applied the template. But not anymore.@Kayle MillerDo share here or send them to mali.zeleni[at]gmail
