I have a VG202 configured with SCCP with CME 8.6.
I cannot get fax to work reliably. The fax call comes in and my fax machine answers. The call terminates after a period of time. Typically less than 2 minutes but often less than one minute.
I h...
Thank you for posting this. I thought I was going to have to reconfigure my switch. What an odd problem and odd solution. But thankful that there was a solution!
Here is the show inventory:
NAME: "3825 chassis", DESCR: "3825 chassis"
PID: CISCO3825 , VID: V05
NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 0", DESCR: "2nd generation four port FXO voice interface daughterca...
I've completed a packet capture at this link.
https://www.dropbox.com/sh/hrrsxqjdzwd5l8z/AAACzK0x1U-K3LnbzGj6pRQla?dl=0
I'm unable to discern any details from them other than that the call took place. None of the fax calls listed in these caps w...
That is very good information. Thank you. I did as you suggested and configured both as modem pass-through.
I'm not totally sure the elevation to modem is happening on the CME router here is the out put of the show call active voice:
CME:
110F...