We are currently using GLBP on two routers to load balance the lan traffic between them. However we would like to have one subnet alway use a specific router so it will use a specific route to a backup site. Is it possible to remove that subnet from...
We are having trouble with a pair of sites which have two site to site VPN links between them. There are two 3845 routers at each site, A and B; The A router has a vpn link to the other site by the A router at that site, and the same for the Bs. On t...
I have an ASA 5520 on which I've enabled EIGRP. There are two routers to which it is a neighbor and these have equal cost distance to a network across the network. The network will automatically load-balance but the default is on a per destination ba...
Hi,I'm new to VoIP and would like some advice:Two of our sites have a dedicated E3 connection between two 3845 routers (IOS Version 12.4(3e)). The connection is currently used for data only but it is not fully utilized and we would like to use it to ...
One of my failover pair of ASA 5520s need to be replaced. It is the primary unit. Will the following commands suffice:interface GigabitEthernet0/3 description LAN/STATE Failover Interface speed 1000 duplex fullfailoverfailover lan unit primaryfailove...
Jon,I don't think going down one VPN and the return traffic over the other VPN is the problem since these are site to site VPNs We're actually only having the problem on sub-interfaces which are configured on an NM-1GE in slot 4 on the two routers at...
Hi Jon,Thanks for the reply. I don't think it is because each of the subnet includes a line similar to:glbp 123 load-balancing host-dependantwhich should make each node use the same router each time. I'm not sure how to tell if it is actually working...
