About ohalnet53

ohalnet53 · 03-04-2010

Hi mates : )I am trying to understand multicasting. It is IP based (Layer 3) soo looks i need a layer 3 device for multicast traffic. Can i realize multicast communication without routers?i'll appreciate if you can answer the below questions ;1. Lets...

ohalnet53 · 11-04-2009

hi mates :)pls see the attached figure i draw for you shows my network.- Location A and Location B is working OSPF right now without any problems.- we want to add a new WAN node(C) but they want computers to have the same network ID on two WAN nodes ...

ohalnet53 · 08-05-2009

how do we understand if routers are load balancing the data transmition?Configuration:there are 2 routers (A and B)at the center and 2 routers (C and D) are at the remote site.A is connected to C (E1)B is connected to D (E1)OSPF is the routing protoc...

ohalnet53 · 07-04-2008

hi :)mates I'll really appreciate if someone can help me about enabling diff-serv on 4503 switch.- we have hosts directly connected to 4503 switches.- packet priorities are set on the hosts according to rules defined in diff-serv. (bits are set in IP...

ohalnet53 · 07-02-2008

hi mates :)I'll appreciate any help about below described problem;Customer asked me to implement QOS on his 4503 switches.- it is a simple Layer 2 network without VLANs. - two 4503 switches are connected to each other using etherchannel- some compute...

ohalnet53 · 03-04-2010

thanks jon,whenever i see your name on the reply, i am sure the question is answered in a way everybody understands.

ohalnet53 · 11-09-2009

hi sohailian,i've updated drawing and add serial interface IP Address block.ty for trying to help

ohalnet53 · 11-04-2009

ty for your fast response but i am not sure if that solves my issue.lets say there is a pc with 192.168.10.1 on location Bandthere is a pc with 192.168.10.2 on location C,how can router 2 understand which IP belongs to B, which IP belongs to C and se...

ohalnet53 · 08-05-2009

hi joseph :)thanks for replying2 routers at the center are connected to each other via a multilayer switch, OSPF is running on that switch too.for router A and B (routers at the center); output of #show IP route , shows both paths. in this case can i...

ohalnet53 · 07-04-2008

there isn't a "shut down" command for those active devices.you must physically turn off the power.

Member Since	‎01-24-2006 01:31 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	101
Total Helpful Votes Received	1

User Statistics

User Activity

Simple MULTICASTING question

how to reach 2 wan nodes that has LANs with same network ID

simple load-balance question

how to enable diff-serv on 4503 ?

QoS configuration on 4503

Re: Simple MULTICASTING question

Re: how to reach 2 wan nodes that has LANs with same network ID

Re: how to reach 2 wan nodes that has LANs with same network ID

Re: simple load-balance question

Re: how to safely turn off cisco router/switch?