If there isn't an explicit vlan mapping in the FlexConnect group then the WLAN will map to the VLAN specified under the WLAN config. However if VLAN support is not enabled for the FlexConnect group then traffic tagging is not supported and so the tra...
I've configured a few of these and got stuck with this same issue. I then realised I'd not followed the instructions exactly as shown, specifically; Would you like to terminate autoinstall? [yes]: noInitially i'd just pressed enter, got to a command ...
If you're using FlexConnect did you use a FlexConnect ACL and push it to the AP's as a Policy ACL (done via the FlexConnect group config)?Also the redirect won't work if it's an allow all ACL. It needs to hit the deny rule to be redirected to the por...
Although the VLAN part of the flex profile allows you to assign an ACL it doesn't push it to the AP itself. For that you'll need to use the Policy ACL tab. Just select the appropriate ACL in there, with nothing else and it'll get added to the AP. Wit...
