Sorry, last question here. Does the switch always boot from flash:? Do I need to copy those file sys...

It is all done, thank you so much! Quick recap in case someone comes across this and needs help:copi...

Good news is that following that guide did work. However, I only loaded the bin file but I want the ...

Okay, I am transferring c2960s-universalk9-mz.122-55.SE13.bin to flash: via xmodem I will let you kn...

And this is the log after flash_init: =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2019.08.12 15:01:12 =~=~=~=~...

Here is the boot log:=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2019.08.12 12:59:20 =~=~=~=~=~=~=~=~=~=~=~=@U...

I posted some console information under another comment in this thread. As it stands now, the consol...

I'm sorry, I came down with a cold and it floored me for a week. I've attached two txt documents. Th...

More output. I did ? and I also did flash_init

I also went through steps to re-flash and I still get the same error. I followed these steps:Connect...

Got the console output, it is attached:Error is "Boot process failed...The system is unable to boot ...

I'll let you know. But, if it was factory reset, wouldn't it have at least 512? I assume they wouldn...

I'm not sure about that. I did a factory reset when I received it, so it should've been completely e...

I don't have any of the cables listed, so unless I can use a straight networking cable, I'll have to...

Here is the video