moman62
Level 1
Level 1
Member since ‎04-29-2018
‎04-19-2024

User Statistics

  • 90 Posts
  • 3 Solutions
  • 25 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
50 Replies
20 Replies
1 Helpful Vote
10 Replies
5 Replies
1 Accepted Solution

User Activity

Hello, I have a cisco 2921 router and I would like to know how to enable port 5060 so that my ITSP can send information so I can perform outbound/inbound calls.
My cisco 3750E POE switch is setup with the following:3 separate Vlans 192.168.70.0, 192.168.80.0, 192.168.90.0 On my switch, I can ping all the gateways and also the pc's on each vlan but on the pc's I can only ping the gateways of each vlan and not...
Hello, I wanted to know that in order to connect phones to my ITSP using sip, do I need to use CUBE? or is there another way in CUCM I can do this without CUBE?
I have a cisco 8961 phone that I have hopefully set up correctly in CUCM 11.5. I have also downloaded and put in my tftp server the sip upgrade .sgn file. When I plug the phone in, I reset it to factory default and it gets an ip address from my windo...
Hello, I am confused by all of the licensing for CUCM, I would like to purchase CUCM 11x license for 5 users and would like to know what is the difference between the following: enhanced licensepermanent licensebasic license  
Community Statistics
Member Since ‎04-29-2018 10:27 PM
Date Last Visited ‎04-19-2024 12:05 AM
Posts 90
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To