Have any of you use WCCP on 6.3.0 release. We have 6.3.0 deployed with WCCP configuration but it is not working. I can see the config in the FTD when using the show commands but it is not sending any traffic to the WCCP appliance. 

I was having an issue with an inbound dial peer where no matter what the outbound dial peer was it was delivering the the SIP invite with the wrong information in the "to" portion. It was delivering the to portion with the ip address of the out side ...

I am on the same version and hardware. I did confirm that it is IPbase and I am experiencing the same issue. Any one else having this issue?