About ranimbouraoui

ranimbouraoui · 02-01-2017

Hello, I would like to configure Port forwarding on ASA 5512 v9.2, but no chance to get it up and running. My topology is the following PC(Running License Server in port 27000 IP. 192.168.X.X) -- SW (192.168.X.X) -- Inside--FW5512 --Outside -- Inte...

ranimbouraoui · 03-10-2016

Hello, I have a problem joining 10 CISCO AP's 1041N to a WLC 2500 Series. I have the following network architecture, A Windows Server 2012 R2 (DC, DHCP and DNS Server) connected to CISCO 2960-X Series (This switch is connected to 2 other switches, s...

ranimbouraoui · 03-06-2016

Hello, I have an IBM Server with 4 NIC's and 3 CISCO 2960-X 48 Port PoE Switches, my question is about the best architecture I can use with the hardware I have in order to get a good networking performance, the 3 switches are separated, each one in ...

ranimbouraoui · 02-01-2017

Hi, This is the output:

ranimbouraoui · 03-12-2016

Everything is up and running, I installed the image on the AP's and they are able now to join the controller using Option 43. Thank you for your help.

ranimbouraoui · 03-10-2016

Maybe this could help, ap#show configUsing 1410 out of 32768 bytes!! Last configuration change at 01:51:07 +0100 Mon Mar 1 1993! NVRAM config last updated at 16:13:39 +0100 Tue Mar 8 2016! NVRAM config last updated at 16:13:39 +0100 Tue Mar 8 2016ver...

ranimbouraoui · 03-10-2016

Thanks for the answer, I have enough licenses for the WLC (10 in total) I tried the command and I got the following message ap#capwap ap controller ip address 192.168.1.7 ^% Invalid input detected at '^' marker. ap#

ranimbouraoui · 03-06-2016

Thanks Leo for your answer, The idea is to make the 3 switches like clients to the server (Internal, DC, DHCP/DNS Server) with the 4 NIC's, so I want the 3 switches to act like a bridge to clients (CISCO WLC, CISCO AP's, Smartphones, Laptops, Printer...

Member Since	‎12-08-2015 09:53 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	11

User Statistics

User Activity

Configuring port forwarding

Joining CISCO AP 1041N to a WLC 2500 Series

CISCO 2960-X Switches and Server with 4 NIC's

Hi, This is the output:

Everything is up and running,

Maybe this could help,

Thanks for the answer, I have

Thanks Leo for your answer,