About USD SmartAlerts

USD SmartAlerts · 04-21-2021

Our Cisco C170 ESA (Version: 11.0.4-003) is randomly (apparently) ignoring some of the white listing we've put in place. We've opened a case with Cisco support, but I wanted to post on the forum as well. We only white list email addresses. Sometimes ...

USD SmartAlerts · 10-03-2019

Is there a way in Async 11.0.3 (Ironport ESA C170) to set two different intervals for the spam quarantine notification? We currently have this set to three times daily, however, our customer Service department needs to have these notification be more...

USD SmartAlerts · 10-01-2019

I have several message filters that were created by my predecessor who is no longer with the company. Is there a way to edit them or do I have to remove/re-add them?

USD SmartAlerts · 08-20-2019

I am trying to get AMP for ESA set up on our IronPort C170 appliance running ASyncOS 11.0.3. I believe I have my settings correct, however, files that have a verdict of unknown are not being uploaded for analysis. Perhaps I'm missing something? I hav...

USD SmartAlerts · 07-25-2019

I use this method to backup all my switch configs: show running-config | redirect tftp://10.10.10.200/coreswitch.cfg However, I am having an issue getting this to work on our core switch. I do not get any errors. It outputs a 0 byte file. Here is the...

USD SmartAlerts · 04-21-2021

Nevermind, it is due to DKIM failures in the header. I just got clarification. So, it is working as designed. I will close this.

USD SmartAlerts · 08-21-2019

Thank you everyone for your help with this. In reviewing the AMP log, I found that it does show that the 'UNKNOWN' file was not sent for analysis and gives the reason as 'No active/dynamic contents exists'. In reading other posts and the documentatio...

USD SmartAlerts · 07-25-2019

Thanks for this! I tried setting the blocksize to 8192 and min-timeout to 20, but it stills gives me the o byte file. This is the method I use on all my access switches, but it doesn't seem to want to work on the core.

USD SmartAlerts · 07-25-2019

I haven't used that before, but it looks like a good option. The only issue I seem to be having with that one is that I would prefer a single file only, without a time stamp or version. Right now, it gives me 'coreswitch.cfg-<timestamp>-1. Also, I ca...

USD SmartAlerts · 07-25-2019

Thank you for that! It worked. Now the question is: How do I make that work with kron? I have been using kron to automate the backups each night, but when I run the 'copy' instead of 'redirect', it wants additional input (even though I am only hittin...

Member Since	‎04-30-2018 03:01 PM
Date Last Visited	‎05-07-2021 01:28 AM
Posts	13
Total Helpful Votes Received	5

User Statistics

User Activity

C170 ESA IronPort whitelists being ignored randomly

enable different spam quarantine notification intervals

How to change message filters

AMP not sending unknown files for file analysis

Redirect of running config results in 0 byte file

Re: C170 ESA IronPort whitelists being ignored randomly

Re: AMP not sending unknown files for file analysis

Re: Redirect of running config results in 0 byte file

Re: Redirect of running config results in 0 byte file

Re: Redirect of running config results in 0 byte file