I'm migrating a ACS 4.2 to 5.5, in a previous version 4.2 we had the option to remove access to shell, but without affecting the tacacs authentication for, eg a VPN. I can not find that option or something like that in version 5.5, any ideas?
Hello, I have in my iphone on cisco Moblile 8 and Jabber, I can make calls using my force authorization code with Cisco Mobile 8, but when try to use the Jabber keyboard is not enable to put my codeAny ideas?
HI, yesterday at night, I try to migrate a JUNIPER to ASR. The BGP configuration is very simple, but the BGP n never UP, with show bgp nei every time stay en ACTVE mode. Attached the configuration and the show log. TOday I will be do Labs betw...
HII need to configure ASR 9006 with this configuration.OLD and good configuration:access-list 199 deny ip any 186.32.128.0 0.0.31.255 logaccess-list 199 deny ip any 186.32.224.0 0.0.15.255 logaccess-list 199 deny ip any 190.53.48.0 0.0.15.25...
Hi guys, I need to implement two datacenters on different location. I have a little question. Scenary: Both Datacenter will have cisco nexus 7010 in the core, and I need to configure two ACE in each site. My question is, can I configure 2...
Hi GuysThe last saturday we found a post about problems with ASR interconnection with Juniper M10i and the solution was the router id configuration. We configured ROUTER ID and the BGP pass the active to establish status immediately and wonrki...
HI, about the inboudn policy i will the configure in afew minutes in a litle labs, and the command doesn't work check the outputRP/0/RSP1/CPU0:ASRAmnet#sho run lpts pifib hardware police flow ...
