Hi everyone, Looking for some help with one of our 3850 stacks which is getting this within its logs: SPANTREE-2-LOOPGUARD_BLOCK: Loop guard blocking port Port-channel1 on VLAN0102. The stack has 1 uplink to our core switch configured with the below ...
Hi all, I am trying to configure within CUCM a forward within office hours and then a different forward out of hours.DN is 4460in hours this needs to forward to 5888and out of hours this needs to forward to 4470 Could anyone help please ?
Hi all, Looking for some help here with this router, seems to be currently stuck in a boot loop with the below. I have tried booting straight from rommon mode but i just get the same. I have also tried a USB with a new version but unable to see this ...
Hi @paul driver Correct there is only 1 physical interface connected to this switch stack from our core switch. There should be two interfaces but it looks like this was missed. If we were to have two interfaces to the core both within the PC would ...
Hi @Giuseppe Larosa Thank you for the information. Yes correct it looks like its enabled at the global level. Using the commands show spanning-tree inconsistent ports it shows 0 ? Thank you
