About kevinjmorse

kevinjmorse · 02-15-2017

Hi there, I purchased some used SPA50x off of eBay and am unable to get them to do anything other than display Downloading When plugged in they do the usual Initialize Network and then display Downloading of the following files SEP_mac_address_.cnf.x...

kevinjmorse · 09-17-2012

Hi there,Just purchased an RV220W for a customer to replace a WRVS4400N that had no support for One-to-One NAT and have found the One-to-one NAT for this router is only marginally better.I have three WAN addresses and three devices to map them to. Wi...

kevinjmorse · 02-15-2017

I purchased some used SPA50X off of eBay and am unable to get them out of SPCP mode. Upon bootup they display Downloading and change between the following files SEPmac.cnf.xmlXMLDefault508G.cnf.xmlXMLDefault.cnf.xml I have setup a TFTP server and the...

kevinjmorse · 09-20-2012

Thanks tekliu,That was what I was looking for.I didn't realize that Access Rules on the RV220W actually enabled you to specify NAT as part of the settings.The working settings were as follows:Action: Always AllowService: SSH-TCPSend to Local Server (...

kevinjmorse · 09-20-2012

This question is 100% about routing and 0% about wireless. Looking at the posts in the Small Business - Wireless forum I believe this to be in the right place.Cheers,Kevin

kevinjmorse · 08-10-2012

What should be entered in the Voice Mail Server parameter? Should it be the server's IP address or the IP address followed by the port number?Also what is Voice Mail Subscribe Interval for? The default is 86400 which is one day in seconds?My Message ...

Member Since	‎08-10-2012 05:47 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5
Total Helpful Votes Received	10

User Statistics

User Activity

SPA50x cannot reset or provision used phones

RV220W One-to-One NAT only allows a single service?

I purchased some used SPA50X

RV220W One-to-One NAT only allows a single service?

RV220W One-to-One NAT only allows a single service?

SPA504G: MWI for Voicemail