Hi, I would like to know in AMP endpoint protection, can we control peripheral devices like USB, DVD as Block, read only and full permission. Hope your advice
Hi,
Skype configured in CME9.1.. But call not going outside. Hope you support. Pls find the below debug details.
debug ccsip all This may severely impact system performance. Continue? [confirm] All SIP Call tracing is enabled ...
Hi, I'm have Cisco CME with version 8.6 and configured SIP trunk to action voip. But when I try to call, I'm getting busy tone. Debug file I attached down here. Hope your prompt support . My router SIP related configuration is as below. Voice servi...
hi, I'm using Cisco WLC 2504 with 4 SSID in our company. When I try to connect second SSID by using Iphone, it showing an error like "unable to join to the network". If I completely forget the first SSID, then I can connect easily to second one. I t...
Hi,Recently we changed our core switch from Nortel Cisco WS-C4510R+E. After the migration Some of our server always getting ip conflict issue. So I checked in server log to know with which device is getting conflict. I got one mac address and I sear...
Hi, Thanks for your reply EHEVoip#show run | sec voice service voipvoice service voip ip address trusted list ipv4 192.168.203.225 allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to ...