About Chris Bailey

Chris Bailey · 03-16-2016

I have a Cisco 3725 as my core router and have my WAN assigned to Fa0/0 and LAN on FA0/1 as well as VLANs on FA0/1.1,1.2, 1.3, and 1.4. I have a series of SLM2024s and Catalyst 3750s and all VLANs are behaving as they should. I also have a block of...

Chris Bailey · 09-21-2012

I have a 2821 router w/ SLM 2024 switches. Native VLAN(default vlan) is my private network and VLAN 100 is my guest network. The following shows my interface config...interface GigabitEthernet0/1description $ES_LAN$$ETH-LAN$ip address 10.1.0.2 255....

Chris Bailey · 03-17-2016

Jon this seems to have done the trick. Thank you very much sir!

Chris Bailey · 03-17-2016

In doing this do I also have to apply this acl to an interface to get it all to work?

Chris Bailey · 03-17-2016

Ok so I just enter the above commands without this... route-map VLAN300 permit 10match ip address 101set ip default next-hop 99.99.99.1 <<ISP cable modem/gateway and all should be good correct?

Chris Bailey · 03-17-2016

Jon, It's not a typo...there is one gateway. I want to use the same gateway just have vlan300 use an different external IP.

Chris Bailey · 03-17-2016

Thanks Jon, So if I remove the 2 acl175 lines and add the following all traffic originating from VLAN300 will be see as coming from my other WAN IP of 99.99.99.5 to anyone on the web correct? interface FastEthernet0/1.4 ip address 10.20.1.1 255.255....

Member Since	‎09-21-2012 10:42 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	11
Total Helpful Votes Received	5

User Statistics

User Activity

Route a specific VLANs internet traffic out using a different wan IP from my primary wan IP

Allow VLAN on sub interface internet access but block traffic to native VLAN

Jon this seems to have done

In doing this do I also have

Ok so I just enter the above

Jon,

Thanks Jon,