About Romeo Sulzer

Romeo Sulzer · 10-25-2015

Dear Cisco CommunityI've just setup a RV042G router and installed the latest firmware (v4.2.3.06). Everything seems to work great with the exception of SSH connections. I have a SSH server on the LAN and w/ the Stateful Inspection Firewall enabled o...

Romeo Sulzer · 06-23-2015

We have the following setup:SG-300-28 Switch in Layer 3 ModeSG-200-08P Switches in every office roomVLANS:100 = Data200 = ManagementOn the SG-200 I set the Management VLAN to 200, this has the effect that one of the ports needs to be an untagged memb...

Romeo Sulzer · 09-01-2014

Dear Cisco Community,We have the following setup1 x SG300 Switch in Layer 3 ModeVLAN 100 (Management VLAN)VLAN 200 (Data VLAN for Internet Users)The SG300 has an IP4 Interface in each VLAN:100: 10.1.1.254 / 24200: 10.1.2.254 / 24The internet gateway ...

Romeo Sulzer · 01-28-2014

Due to its dual WAN feature, we replaced our Linksys EA4500 Router with a Cisco RV042G. Attached to the RV042G router is a Cisco SG300-10 Switch in Layer 3 Mode. The LAN is structured as follows:VLAN 100 (Internal Clients) 10.1.1.0 / 24 Default Gatew...

Romeo Sulzer · 09-10-2012

Hello there,I am trying to get WOL working across different VLANS on a SG-300-10 Switch in Layer 3 Mode. To achieve this, I've setup an UDP-Relay (GUI menu IP Configuration) for UDP-Port 7 to 255.255.255.255 (this should flood all interfaces with th...

Romeo Sulzer · 06-23-2015

Hi Tom,Thanks for your advice. I will check again and if the GUI really requires me to assign the mgt. vlan untagged to at least one port I will do as you have suggested. Thanks a lot! Kind regards,Romeo

Romeo Sulzer · 06-23-2015

Hi Tom Thanks for your reply. If I remember correctly the SG200's GUI requires that the management VLAN is untagged on at least one port. Currently I don't have a SG200 lying around to test this. I will check again the next time I am on-site. Kind...

Romeo Sulzer · 06-23-2015

I would like to know the same thing. We have quite a number of SG300 switches, would be a pity if they only marginally support IPv6. Would be interesting to know if this is a hardware or firmware limitation?

Romeo Sulzer · 08-21-2014

Any update from Cisco? We have approx. 10 Cisco SG300 switches, can we expect more sophisticated IPV6 support (routing) in future firmware releases?

Romeo Sulzer · 07-13-2014

I also need the IPV6 static routing feature for multiple VLANs on my SG300 switches. In total I manage about 10 SG300 switches.

Member Since	‎09-10-2012 02:44 PM
Date Last Visited	‎08-18-2017 06:35 PM
Posts	18

User Statistics

User Activity

RV042G - cannot establish SSH connection on lan w/ SPI enabled

Management VLAN on SG200 Switch

SG300 Redirect HTTP Traffic to Proxy

Connectivity Issue with RV042G and SG300-10 Switch (Layer 3)

Wake on LAN (WOL) across different VLANS on SG-300-10

Hi Tom,Thanks for your advice

Hi Tom Thanks for your reply.

I would like to know the same

Any update from Cisco? We

I also need the IPV6 static