About rwesel

rwesel · 04-28-2022

Hello,I try to remove a policy-map I don't need anymore.But I get an error messageswitch(config)#no policy-map type control subscriber MONITOR_MODE_MAB_POLICY%policy-map "MONITOR_MODE_MAB_POLICY" currently associated with at least one interface or te...

rwesel · 04-25-2022

I have a policy-map (type control subscriber) and bound it to an interface.policy-map type control subscriber DOT1X_MAB_FAIL10... event authentication-failure match-first ... 50 class always do-until-failure ... 30 authentication-restart 60...

rwesel · 03-18-2022

Hello,I try to block some calls on the incoming dial-peer but have to translate 1 special number.+4930123450 => translate to +493012345999+493012345 + 2 digits => reject+493012345 + 1 digit => reject !!!Here is my config dial-peer voice 1 voipdescrip...

rwesel · 11-09-2021

Hello,we have a CUCM 12.0 and I'm stuck with creating a presence policy.Our goal is nobody should be able to watch the presence status of another user (U).Except the status of some Assistants (A) should be visible by everybody.U => U = status not vis...

rwesel · 07-12-2021

We have 2 C9500-32C in StackWise Virtual Mode with about 20 SVIs acting as router.To serve DHCP for clients in these VLANs we configured ip-helper addresses in every SVI.It all worked very well.But for some time now it seems that sometimes the DHCP R...

rwesel · 04-29-2022

The switch isWS-C4510R+ECisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500es8-UNIVERSALK9-M), Version 03.11.04.E RELEASE SOFTWARE (fc2)

rwesel · 04-29-2022

Unfortunately, deleting the port channel as well as rebooting the switch is not possible.

rwesel · 04-28-2022

Hello Flavio,thanks for your hint. I forgot to say, that I tried this already. But no luck. Maybe it's not so important to remove an unnecessary policy-map, but I wanted to clean up my configs. Stefan

rwesel · 04-28-2022

Sorry, I was wrong. Apparently, the changes to the policy-map will take effect immediately.

rwesel · 03-21-2022

Hello @Roger Kallberg sorry I wasn't quite correct.Of course I configured an incoming translation-profile AND an incoming call-block in the incoming dial-peer.But still the call-block matches first and the translation never happens.Unfortunately it o...

Member Since	‎09-23-2009 09:54 PM
Date Last Visited	‎05-06-2022 12:04 AM
Posts	40
Total Helpful Votes Received	26

User Statistics

User Activity

Removing policy-map not possible

Modify policy-map

CUBE translation-rule doesn't work - "Skipping a call block rule"

Presence Policy Configuration

DHCP relay broken - C9500-32c StackWise Virtual

Re: Removing policy-map not possible

Re: Removing policy-map not possible

Re: Removing policy-map not possible

Re: Modify policy-map

Re: CUBE translation-rule doesn't work - "Skipping a call block r