Hello Gurus, I am facing an unusual behavior in UCSM 4.0 (2b) while using inband KVM access. Everything working fine, Service Profiles are getting IP from Inband Pool. Accessible and KVM launch is also working. IP Pool Size is of 16 IPs and 3 are use...
Hello Team, I have one interesting query related to FI failure detection delay. Lets say one of my FI got failed ? Detection time and tries? Is the failure detected with zero delay or only after a delay of x seconds ?If there is a delay of x seconds,...
Hello Guru'sIst Question:Problem is IPs from "ext-mgt-pool " pool is out of stock . Is there any alternative to expand it or create new IP Pool with in Outband or Inband? currently we are using outband.The KVM IP Address has to be from the same subne...
Hello, This is regarding one of the critical alert in UCSM, Details mentioned below "code="F999790"created="2018-06-25T18:15:48"descr="[FSM:FAILED]: vnic qos policy xyz-QosGold removal(FSM:sam:dme:EpqosDefinitionDelTaskRemove). Remote-Invocation-Erro...
Hello Experts,
I need your help in re-config HX Platform. Situation is, I have to perform POC of Hyperflex but initial configuration has been performed by CISCO. Now i want to destroy everything, except VCSA & FI configuration.
What steps i have ...
Thank you Afroj!! Remaining IP's was picked by CIMC of each server. So i went to each server >> Inventory >> CIMCThen "Change In band IP Address" and set not set/None.And it worked. Thanks a lot !! Cheers Andy !!
Thank You Krik for your reply! I know the fail-over mechanism and vNic part is clear to me.My question was specific to vHBAs, If FI- A went down then how much time it will take to detect error and switch the FC traffic FI-B.And during that failure , ...
Hello Wes, Thank you for your swift response.Further query is do we need to config both Out-of-Band & In-band with new IP Pool ?Or just In-band with new IP Pool? This pool can be a different subnet from FI? Cheers !Andy.
Hello Krik,
Thank you for your reply !! Find below the answers.
Yes, from UCS service profile prospective iscsi VNIC is pulling the intended IP fine from the pool, but vmk port pulling the IP which was in tab "Prev Assigned To". This the weird behavi...
Hi Wes,
I tried running command "show interface counters errors" on both the FI's.
Network Ports in FI-B showing FCS and RCV erros more than 300 & 400 respectively.
Server Ports in FI-A showing FCS and RCV erros more than 800 & 1000 respectively.
...
