Good Morning!
I have a 4x 2802i APs that need to associate to a 5520 Controller. They are on the same subnet/vlan with the same gateway.
The tricky part is that we cannot connect the SFP+ cables yet, as they are being ordered.
How would I go ab...
I was surprised as well, even on 15.2 all you need is:service unsupported-transceiverno errdisable detect cause gbic-invalidUnfortunately, I'm not sure that the controller supports that in any fashion. Thanks for the quick response!
Thanks for the illustration! We obtained a third party direct-attach copper 10G cable, but despite configuring the switch to recognize unsupported transceivers, I am still unable to get link lights on the connection. Is there some way to enable third...
I appreciate that, it seemed strange when I was told that you could perform all traffic functions through that "M" port, especially considering that port serves as a management interface for the overall chassis.Thank you for confirming my suspicions!