Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About billlfilt
Stats
Member since
12-07-2009
5
Posts
0
Helpful
0
Solutions
Created by
billlfilt
in IP Telephony and Phones
in IP Telephony and Phones
04-30-2010
08:31 PM
04-30-2010
08:31 PM
Can a third party sip client (eg. xlite) on the Internet securely register to UCM (using digest authentication) via the ASA Phone Proxy feature?
... View more
Labels:
Created by
billlfilt
in IP Telephony and Phones
in IP Telephony and Phones
12-09-2009
05:50 PM
12-09-2009
05:50 PM
Adding the codec preference list to the dial peer got it working. Is there any debug commands I could have run to determine which codec the call was trying to use at the time?
... View more
Created by
billlfilt
in IP Telephony and Phones
in IP Telephony and Phones
12-09-2009
08:14 AM
12-09-2009
08:14 AM
I'm not sure what you mean My dial-peers are currently defined as follows: dial-peer voice 1 pots incoming called-number . direct-inward-dial port 0/0/1 ! dial-peer voice 2 voip destination-pattern 5041231234 session target ipv4:1.1.1.6 dtmf-relay h245-alphanumeric ! dial-peer voice 3 pots destination-pattern .T port 0/0/1 forward-digits all !
... View more
Created by
billlfilt
in IP Telephony and Phones
in IP Telephony and Phones
12-08-2009
07:56 PM
12-08-2009
07:56 PM
We've got CallManager lab set up with a SCCP phone registered to a "internal" CM7.1 publisher. The "internal" CM and a 2821 is setup to do MGCP BRI backhauling of one of the VIC2-2BRI-NT-TE interfaces(0/0/0). The 2821 has a BRI cross connect wire between interfaces 0/0/0 and 0/0/1. The 2821 is also configured for H323 and has dial peers associated with BRI interface 0/0/1. Another "pstn" CM7.1 publisher registers with the 2821 via H323. We also have xlite registered as a SIP client to the "pstn" CM. Whenever the SIP client dials the number of the SCCP phone, the SCCP phone does a short ring and then stops. Can't seem to establish a call at all but some type of alerting is getting to it.. Any ideas?
... View more
Labels:
Created by
billlfilt
in IP Telephony and Phones
04-30-2010
04-30-2010
Can a third party sip client (eg. xlite) on the Internet securely
register to UCM (using digest auth...
12-12-2009
I'm looking to lab voice and video over a BRI connection. At this point
I've got a CallManager lab s...
Created by
billlfilt
in IP Telephony and Phones
12-09-2009
12-09-2009
Adding the codec preference list to the dial peer got it working. Is
there any debug commands I coul...
Created by
billlfilt
in IP Telephony and Phones
12-09-2009
12-09-2009
I'm not sure what you mean My dial-peers are currently defined as
follows:dial-peer voice 1 pots inc...
Created by
billlfilt
in IP Telephony and Phones
12-08-2009
12-08-2009
We've got CallManager lab set up with a SCCP phone registered to a
"internal" CM7.1 publisher. The "...
Public Statistics
| Date Registered | 12-07-2009 08:51 PM |
| Date Last Visited | 08-18-2017 03:53 AM |
| Total Messages Posted | 5 |
