edomatic007cisco
Level 1
Level 1
Member since ‎05-11-2018
‎08-30-2023

User Statistics

  • 38 Posts
  • 0 Solutions
  • 21 Helpful votes Given
  • 10 Helpful votes Received

User Activity

Hi, is it wise to use the install mode on cisco 1111-4p like we do on switches? We used to do it with bin file, i tried it with install mode using package.conf to boot off and that works. Is this the recommended way now for all cisco devices that run...
Hi guys,   I need some help converting the bellow eem script to tcl script for a cisco catalyst 9300 switch without the addon license pack ( so i cannot run the eem script without first rebooting the switch which i cannot do) I tried the eem to tcl c...
Hi,i am trying to find out if it is possible to add a string value like "cisco" to another string like "test" to finally form |"ciscotest" using an eem applet/script or maybe in terminal shell ?i am looking to do this:i want to skim the sh log for in...
Hi Guys, I am looking for a way to see if traffic(packets) are increasing on a specific mapped vlan from traditional QinQ tunnel on a trunk of a cisco 4500Is this possible? I do not need to look into the packets i just want to see if traffic is trave...
the eem applet that causes this output is: action 0011 cli command "enable"action 0012 cli command "sh run | i ^line vty"action 0013 foreach line "$_cli_result" "\n"   when i run this with debug action cli activated i see this behavior of EEM: R1#sh ...
Community Statistics
Member Since ‎05-11-2018 07:37 AM
Date Last Visited ‎08-30-2023 12:33 AM
Posts 38
Total Helpful Votes Received 10
Helpful Votes From
Helpful Votes Given To