rugman66
Level 1
Level 1
Member since ‎05-11-2018
‎12-15-2021

User Statistics

  • 14 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hello,I have a UCS C460 M2 that I would like to install a Tesla A100 GPU card Cisco part number UCSC-GPU-A100=. I need to know if there is a firmware issue that would prevent using it, or if it would be too large. The C460 has one PCIe 16x slot that ...
Hello,I just picked up two C200 M1 machines second hand, and have run into an issue. I tested both before I purchased them, and they both POST'd fine so I purchased them. When I got them home I powered up one of them up. It was doing fine but seemed ...
Hello, Below is the general question, I can provide any sh command output.   I have a router with several VLAN’s configured, and need to have a trunk from the router to a c4948 switch. With global and interface CEF enabled on the router layer 2 trunk...
Hello, I have a 3845 router as the GW running an NM-16ESW card with one GigE port being used as the trunk to the backbone c2960x switch. CEF is enabled globally on the 3845 and on the NM-16ESW GigE port. However the NM-16ESW GigE port input queue is ...
Hello,   I have a 3845 router running a GigE uplink, with a NM-16ESW-1GIG line card running a GigE trunk to the backbone GigE switch. The issue is that the line card GigE trunk is dropping allot of packets in the input queue and thus very poor throug...
Community Statistics
Member Since ‎05-11-2018 09:31 AM
Date Last Visited ‎12-15-2021 12:43 AM
Posts 14