Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we are performing a staging and firmware updates on a bunch of C220 M5 standalone servers delivered with CIMC 4.1(2a) loaded. After initial CIMC setup we are able to connect to CIMC GUI, all looking fine, however, we are unable to launch vKVM c...
Hello, team,
please, let me kindly ask the question regarding the formally published storage interoperability matrix for native FC interfaces hosted on unified Nexus 2348UPQ FEXes parented by Nexus 56xx Series switches. It seems that the recently pub...
Hi,
this issue is not related to Cisco solution itself - the root cause was a result of our corporate security policies disallowing self-signed certificates combined with Chrome and MS Edge browsers. The quick solution was using Firefox browser which...
Hi,just an update - problems with loading the vKVM app were tracked down to our corporate domain security policies and self-signed certificate issues when using Chrome based browsers (e.g. both Chrome & MS Edge). Firefox is our friend. Sincerely,Mari...
Hi, Walter,
running N5600 Series parent switch in NPIV mode is not required, you may run it either in regular FC switching mode or NPIV if your design does require it for NPV devices attached directly to N5600 node (e.g. not via FEX ports, since conn...
Hi, Walter,
16G FC is supported on max. 24 FEX HIF ports. If you set the odd interface to 16Gbps FC mode, the neighboring even interface should be put into "out-of-service" state. It means worst case oversubscription is close to 1:1.5 more likely con...
Hi, Walter,
it is, indeed! This is the main reason I am seeking the official guidance from Cisco in order to avoid any speculations and unbacked assumptions.
Sincerely,
Marian
