I'm in the process of setting up a T1 point to point connection between an office and colo facility.  There are Cisco 2801 routers on both ends.  I'm not getting a carrier detect light.  I was thinking perhaps a circuit issue, a clocking issue, or so...

I'm attempting to set up ssh in lieu of telnet on a 2801 router.  It's running IOS 12.4(16a).When I enter in this:Routername(config)#crypto key generate rsaI get this error: "Invalid input detected at '^' marker."What am I doing wrong?  Thanks.

Hi,I'm setting up a Cisco 2800 series router for use with two T1s (bonded).  With the config below (all IPs altered a bit), if I plug a laptop into the FE0/0 port to test (with a public IP address from our 12.187.222.x block) , I can browse the web f...