About tankvishal1108

tankvishal1108 · 04-13-2018

Hi One of my port-channel is showing as suspended because of one port, Speed and duplex are same at both side, can someone help to fix this, Advance thanks. Below is the configuration SWF1# sh port-channel summary interface port-channel 500Fl...

tankvishal1108 · 12-22-2016

Hi guys, I am curious how to check isakmp tunnel up time on router the way we can see on firewall. Ex. On ASA ASA(config)# sh vpn-sessiondb l2l Session Type: LAN-to-LAN Connection : 150.1.13.3Index : 3 IP Addr : 150.1.13.3Protocol : IKEv1 IPsecEncr...

tankvishal1108 · 01-08-2016

Can we establish tunnel using loopback interface configured on router as source address If yes how to configure??? EX Loop 100.1.1.1 ROUTER1(203.11.11.1) ---------- ISP -------------- Partner's ROUTER on my side public ip is 203.11.11.1 ...

tankvishal1108 · 01-08-2016

How to take controll over high cpu utilization on routers and firewall? what are the way to reduce it..

tankvishal1108 · 01-06-2016

what command is used to clear half open connection in ASA firewall and does it help reducing cpu processes ?? What are other way to reduce high cpu utilization in production environment?

tankvishal1108 · 04-15-2018

interface Ethernet1/52 description C::SWF2 switchport mode trunk switchport trunk native vlan 3046 spanning-tree port type network spanning-tree bpduguard disable mtu 9216 logging event port trunk-status channel-group 500 mode active no shutdown in...

tankvishal1108 · 01-08-2016

Thank you both Richard can you give an example of configuration I mean what extra I need to do I was trying to establish but it was not working

tankvishal1108 · 01-06-2016

Hi thnx for replay I know step for establishing tunnel between two point's But before establishing tunnel we use to check end to end connectivity. as you shared a link consider i am configuring site-to-site vpn on router and ASA is other end of tu...

tankvishal1108 · 01-06-2016

Basically I am establishing a tunnel between router and firewall on firewall by default icmp is disable i want check end to end connectivity how can i check that; firewall is not under my administration i have only access to router..

Member Since	‎12-28-2015 06:14 AM
Date Last Visited	‎09-09-2019 01:34 AM
Posts	11

User Statistics

User Activity

Port-Channel is showing as suspended.

VPN tunnel Up time

site-to-site tunnel

High CPU utilizatino

Half-open connection in firewall

Re: Port-Channel is showing as suspended.

Thank you both

Hi thnx for replay

Basically I am establishing a