About corey.burden

corey.burden · 01-31-2022

Hello, I'm trying to connect to a device's console port through an ISR431. It's a new router out of the box. When I connect a laptop to the console port, it works just fine. When I connect the router to the 4351 and try to SSH to the VTY line, I d...

corey.burden · 02-24-2021

Hi, I'm trying to configure a 93180 an allow SCP. I configured an IP 1.1.1.1/24 on the port. On my workstation, I put 1.1.1.2/24. I can ping the switch from the WS but I can't ping the WS from the swtich. I added a default route to .2. Is there...

corey.burden · 12-09-2019

Hi, I'm trying to connect two 93180 switches. However, when I connect the sfp into the switch the amber light on the interface goes out. When I connect the fibers to the sfp, the switches will not establish a link. I defaulted the interface and ha...

corey.burden · 09-19-2017

Has anyone ever seen this problem where the ASDM looks to be like you are on one firewall but you are actually in another firewall? When I open the ASDM using the standby IP it shows that I'm on the standby ASA. The IP address on the deice list for...

corey.burden · 06-02-2017

I am creating an ACL with remark statements. When go to view the configuration the remarks statements are not showing. I'm running an ASR 1006 with 15.0(1)S2. Is there anything that I'm missing? access-list 160 remark --------------------------...

corey.burden · 02-01-2022

Good point. I can check it on this device but the first one I used I set up SSH and generated and RSA key but still couldn't connect to the VTY port

corey.burden · 02-01-2022

So, Im connecting to the console port via ssh to ISR. The command would be something like ssh -l <username>:30@192.168.1.1. That would take me to the vty line that's connected to the console port. It works with an existing router that is connect...

corey.burden · 02-25-2021

Thanks BB. This was half of the problem. I found the FW was turned back on after it was disabled months ago and another security app was installed on the WS.

corey.burden · 12-09-2019

Thanks. I think we have the wrong qsfp module. The box label and the actual module are different (Cisco and Mellanox).

corey.burden · 12-09-2019

After looking at the adapters closer it appears we have the wrong adapter. Our Cisco box has Mellanox qsfp adaptors in them so it looks like someone has put our Cisco models somewhere else. I have to see if we can find them. Thanks for this link

Member Since	‎12-30-2015 10:49 AM
Date Last Visited	‎02-01-2022 08:23 AM
Posts	33

User Statistics

User Activity

Console access

93180 Management Port Configuration

93180 Interface/Port Link Failure

ASDM issue between active and standy firewall

Access-list remark statement

Re: Console access

Re: Console access

Re: 93180 Management Port Configuration

Re: 93180 Interface/Port Link Failure

Re: 93180 Interface/Port Link Failure