veljko.tasic
Level 1
Level 1
Member since ‎04-14-2008
‎08-18-2017

User Statistics

  • 15 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 17 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hi, I need a little help with WAN design. I already have an WAN infrastructure shown at picture (except L2VPN). AS65001 is branch location, and AS65000 is datacenter. Routers R3, R4 and R5 are communicating between themselves using L3VPN. Routers R3...
Hi,I have two L3 switches in collapsed core and I need to connect them to one router. I know I should run routing protocol between them, but I do not have support for OSPF/EIGRP.Can somebody give me some advice how to route between L3 switches and ro...
Is it possible to exclude single host from NAT 0 and from cyptomap?I have a pix with site-to-site configuration. All hosts can access tunnel only, and cannot go on internet directly. Lines from config:access-list ALL_Traffic extended permit ip 192.16...
Community Statistics
Member Since ‎04-14-2008 09:32 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 15
Total Helpful Votes Received 17
Helpful Votes From
Helpful Votes Given To