Hi! I'm trying to configure the network-clock input source ptp in Cisco ASR901, but is not available. I configure the PTP Slave just need complet the ptp as input source, like ASR920. CISCO-ASR901-01#show run | s ptpptp clock ordinary domain 0clock-p...
Hi, I executed upgrade in ASR9010 with RSP A9K-RSP440-TR and A9K-RSP880-SE, in the previous version (IOS XR 6.1.4 and IOS XR 5.3.3) When I showed the show redundancy the Redundancy node status was NSR-Ready, but with IOS XR 6.4.2 the status is: NSR-n...
Hi, I'm facing an issues in my network. I'm using two types of redistribution: OSPF into OSPF also OSPF into BGP. Everything is working fine while no link failure, so when this is present I lost connectivity with some elements in the network, I need ...
Hi, I'm facing issues with a CEM interface, the controller E1 is show Up, also CEM Interface, so I only have ingress packets, not outgoing someone can guide me with troubleshoting or any idea what's happen? see log file.192.168.10.1#show cem circuit ...
Hi Guys, I'm planning to do an Upgrade software from IOS XR 5.3.3 to 6.1.4, I checked the install commit and find the following package: asr9k-asr901-nV-px-5.3.3 ; in config files I don't find anything related information to it package. In the 6.1.4 ...
Hi, if you are using ssh, review the process: "crypto sw pk proc" this probably is increase the CPU utilization when are recreating the Key. Also in the other hands you'll need an upgrade in the box.Regards
Hi, I facing this message in an ASR920 IOS XE 16.05.01, Is possible to set up a limit for the process? I mean configure the process "crypto sw pk proc" to use only 30% of CPU for example. Thanks in advanced.
Hi, from IOS XR 6.2.X was fixed it, the node redundancy is when you'r using clusters nodes, an the Backup Node is related to the process and the RSP acting in Standby mode in the chassis. I'll hope this help you! Regards
