HelloI think we have a problem getting traffic in the VPN tunnel routed across the ISA Server, but I'm stuck. Can you help please?The VPN Client3.5 makes a secure tunnel over the Internet with PIX506 (v.6.01) using Cisco VPN, and can ping the server ...

I use VPNClient3.0.1 to access PIX506 v6.0(1). I believe there are newer versions of these: what benefits would we gain by upgrading?If there are benefits, where do I obtain the upgrades?ThanksMichael

I can set up a VPN from Cisco VPNClient3.0 to PIX506 v6.0(1) and then telnet to a UNIX host on 192.0.0.128, but I cannot get a logon dialog to the WindowsNT Server on 192.0.0.65. The UNIX, NT Server, and PIX inside interface are all on the same LAN 1...

My VPN client 3.0.1 does not even connect to the PIX506 v6.0(1) at Phase 1. The client log shows:SENDING>>>ISAKMP OAK AG(SA, KE, NON, ID, VID, VID, VID) to 193.130.x.y (i.e. PIX outside)It tries 3 retransmissions, then says:Exceeded 3 IKE SA negotiat...

Reading these messages it seems that there are things that don't work yet. Is it possible for a VPNClient3 to get to a network protected with a PIX506 v6.0(1), with a Cisco2501 router between the PIX and the ISP's Kilostream line?Protocols 50 and 51...